Table of Contents

Vxlan config example
- On Ubuntu linux host
- On Aruba 2930F switch

Vxlan config example

The following recipe may configurs a vxlan tunnel between a linux host and an Aruba switch.

On Ubuntu linux host

( Example source )

Create vxlan device vxlan0 with vxlan network identifier 42, remote tunnel host ip and (default) port 4789:
```
sudo ip link add vxlan0 type vxlan id 42 dev eth1 remote 158.38.153.170 dstport 4789
```

Assign ip vtep address and turn up interface:

ip addr add 192.168.0.1/24 dev vxlan0  
ip link set up dev vxlan0

On Aruba 2930F switch

Prerequisits
- Need vlan with static IP, i.e. vlan 2 for port 2 with IP
```
(config)# interface 2 untagged vlan 2
(config)# vlan 2 ip address 158.38.153.141
```
- (The IP set above cannot be on a the same subnet as other IP's set in the switch.)

Enter configuration and enable vxlan tunnels:
```
# configure
(config)# vxlan enable
```

Create virtual network an associate network id 42 and Vlan 2
```
(config)# virtual-network 42 2 "Vxlan-net1"
```

Untested example commands from hp document

vxlan enable
virtual-network 200 50 "vni200"
interface tunnel 13
  tunnel name "VXLAN_Tunnel02"
  tunnel mode vxlan
  tunnel source 10.2.10.2
  tunnel destination 10.220.0.2
  exit
vxlan tunnel 13 overlay-vlan 50